Aaa G.T.S. Reblocking Pty Ltd
Plastering in Yarra Ranges

Tek stumps by stump systems are 75x75mm or 85x85mm concrete stumps with the strength and accreditation for domestic and commercial stumping and reblocking. Tek stump differentiates itself by offering a stump that is smaller and easier to use. The tek stump can be easily fastened to the bearer from both sides through the hoop iron clip using simple chipboard screws. Tek stump has been able to reduce the width, and weight of the stump by using higher grade concrete and a revolutionary core reinforcement that allows the stump to be 25% smaller and lighter, yet strong enough to meet victorian building regulations, making the tek stump an easier to work with, more affordable and more environmentally friendly alternative. The weight of the tek stump makes fastening these stumps noticeably easier especially on those hard to navigate jobs with little clearance.

Te Stump by Stump Systems are concrete stumps with the strength and accreditation for domestic and commercial stumping and re blocking.Te stump has been capable to diminish the width, and weight of the stump by using higher grade definite and a revolutionary core reinforcement that allows the stump to be 25 smaller and lighter, yet potent adequate to meet Victorian building regulations, making the eek stump an easier to work with, more affordable and more environmentally friendly alternative. Call or Visit us to work out what size stump you need, our staff have some fantastic advice and know heaps of info about your sub floor requirements. Te stump differentiates itself by offering a stump that is smaller and easier to use. All thread rod petruding from top for ease in installation and to pull sub floor down in high points. These are the prices based on material costs at the time of publishing. The Te stump is an innovative product designed to keep time and effort for restumpers and builders alike. Made from higher cement content and a revolutionary core reinforcement design (including galvanized Rio), the Te stump has been able to reduce the size and weight of the stump and encourage ease on firm jobs. The Te stump has also proven its adaptiveness to new housing sites, the lighter stump being less inclined to sink into freshly poured footings, resulting in less time packing and a much straighter job. The hoop iron clip acts as a saddle that enables you to mend either side to the bearer using a eek screw, this process allows the stump to be effectively pulled up to the bearer, again limiting the need for packers. The Stump is reinforced with galvanized Rio to thwart rust, and later concrete cancer (When rust expands and causes the concrete to crack), whilst the end of the stump is coated in bitumen paint to prohibit moisture from entering the concrete. The height overhead ground in accordance with table supplied. Stump embedment in bottom material should be at minimum 0.3 of the stump length.